Filter by price
Community poll
How did you find us?
Bus & Coach Suspension Parts
We have a stock of tosilastic suspension parts for buses. We manufacture these parts, they are 100% tested to verify that they have the desired load capacity. In the case of shackles, these do not have a plate but instead have a cast body, which allows for a longer life in buses, at least 1.5 times the useful life. Additionally, they are installed with screws, making installation easier and requiring less time to remove and put on.
We recommend replacing the parts on both sides and the torsilastic shackles so that the rubber works properly and lifts the truck to the same height on both sides.
TORSILASTIC SUSPENSION AND PARTS FOR:
Safari
DINA
- Flxible Hi-Level y el Flxliner
- DINA 311 "Jorobado" or "Olímpico"
- Avante
Omnibus de Mexico
Busscar OISA / Omibus Integrales
EAGLE MODEL
- 15-35' (2 AXLE) INTERCITY COACH
- 15-40' (2 AXLE) INTERCITY COACH
- 15-40' (3 AXLE) INTERCITY COACH
- 15-45' (3 AXLE) INTERCITY COACH
NOTE:
- If you require other parts or the rubber suspension similar to those shown on this page, we can quote the manufacture and delivery of the part.
Eagle arm kit for drive axle torsilastic suspension (Left and Right Arm Kit)
Eagle arm kit for drive axle torsilastic suspension (Left and Right Arm Kit)
Each kit includes
KIT OF TORSION ARMS FOR EAGLE TORSILASTIC DRIVE AXLE
The kit includes 1 left and 1 right arm kit.
Each arm kit includes:
(1) Center piece (LH or RH)
(2) 1/2 Arm (LH or RH) with bronze bushing, grease fitting, orings
(2) Long bolts
(2) Short bolts
(1) kit Adjusting Tensor Rod (with 2 nuts and 4 spacers)
$1,800.00
EAGLE DRIVE AXLE TENSIONER ADJUSTMENT BOLT FOR TORSILASTIC
EAGLE DRIVE AXLE TENSIONER ADJUSTMENT BOLT FOR TORSILASTIC
$100.00
ROUND TORSILASTIC SHACKLE (One)
TORSILASTIC SHACKLE FOR EAGLE / VELVET RIDE SUSPENSION / DINA / OISA BUSSCAR
$154.00
FRONT TORSILASTIC SHACKLE HALF ROUND SHACKLE (ONE)
HALF TORSILASTIC SHACKLE FOR EAGLE / VELVET RIDE SUSPENSION / DINA /OISA BUSSCAR.
$90.00
General Purpose Vibration-Damping Sandwich Mount with Studs
General Purpose Vibration-Damping Sandwich Mount with Studs Vibration-Damping mounts used to minimize vibration between surfaces inside machinery and equipment, such as in circuit boards, vehicle's computers, computers (including lap-tops), small fans, compressors, and pumps. They are for use in compression and shear load applications.
$9.50
Rectangular Rubber Stop
Rectangular Rubber Stop with 2 studs
Flxible Starliner, VL 100, Hi Level & Flxliner Rear Suspension Rubber Stop Number 28
$20.00
- 1
- 2
